• <xmp id="ww0a2">
  • <samp id="ww0a2"></samp>
  • <blockquote id="ww0a2"></blockquote>
    <menu id="ww0a2"></menu>
    <blockquote id="ww0a2"></blockquote>
    成功案例
    首頁 >>> 成功案例

    Mechanisms of Soot Reduction in Diesel Pool Fire by Ferrocene

     
    Spectral flame emission was measured with two MMS-spectrometers (Zeiss) in the range of 0.45 to 0.90 and 0.90 to 2.25 µm and a filter wheel spectrometer 
    produced at Fraunhofer ICT in the range of 2.4 to 14 µm with a sampling rate of 100 spectra per second [16], [21]. Both systems were calibrated on intensity per 
    wavelength with a technical black body radiator. 
    To measure radiation temperatures of the flame a fast scanning 2-colour-pyrometer also developed at Fraunhofer ICT with a sampling rate up to 1 MHz was 
    used [18], [16]. The system presumes grey body radiation with constant emissivity. The detector consists in a Si/Ge-sandwich detector with nominal sensitivities 
    at 0.85 and 1.55 µm. The quotient of the diode voltage that is proportional to the emission intensity is calibrated to temperature using a black body radiator. 
    For the recent application a sampling rate of 10 kHz proved as adequate. 
    All spectrometers and the pyrometer were focused to various locations in different flame zones using a lens system. The resolution of the detected area was 
    estimated to about 100 mm2
    The temperature of the comparatively cold and nonlighting pyrolysis zone in the centre of lower flame was measured with Pt-RhPt thermo-couples. 

    ......http://doc.diytrade.com/docdvr/1016468/23361295/1316500124.pdf

    或直接登記會員下載
    上一篇:蔡司近紅外光譜儀在新釀制麥芽酒生產過程中作在線監督
    下一篇:An online dissolution monitoring test – application sample

    粵公網安備 44030402001426號

    欧美一级A片人与牲口
  • <xmp id="ww0a2">
  • <samp id="ww0a2"></samp>
  • <blockquote id="ww0a2"></blockquote>
    <menu id="ww0a2"></menu>
    <blockquote id="ww0a2"></blockquote>